I have gone through the lessons on how to use the simulator over and over again but when i try to use the simulator it does not work for me. can someone help?
Thanks for replying.
The simulator on this website is the one I am refering to.
I created a simple cct and named the outputs as required but when i run the simulator nothing is happening for a normally open input even if I switch on the input. However with the normarlly closed it just comes on but when i try to change the status of the input nothing changes.
I also tried placing parallel inputs in vain.
I'd never used this 'til a few minutes ago. After some trial and error (and overcoming old habits) I found you have to enter addresses exactly as described.
clear the question mark
enter I
enter slash
enter 0-15
press 'enter'
It appears too that timer parameters are fragile. It looks like timer values are in tenths. I didn't try branches.