So i'm trying to set up an analog input on my SLC 500. I have gone to the card and set up the input channel I am using for channel 0. Set it up for 0-10 vdc and I have verified the channel light is blinking and when voltage is applied it stays solid. My deal is I am kindof stumped as far as where to go from here. right now I have the XIC first pass S1:15 going to the COP instruction. The COP instruction source is #N12:0 and the destination is #O:5:0. From this point can I go online and see the raw data somewhere? Or do I need to make an SCP to see it? Any help is appreciated!!