geniusintraining
Lifetime Supporting Member + Moderator
This is a new processor (2021) sent it to a customer and they said they were having issues so I told them to send it back and I would take a look
It looks like they tried to flash it but something went wrong, see this video of it
I was going to try and re-flash it but now the comms will not work either, anyone seen this before?
Cycle power to unit: Assert in file S:/LNX/NetlinxUCS/NcsSrc/CommPorts/NcsLinkLayer.cpp Line 489
Here is the video https://www.youtube.com/watch?v=GWbV7d-Sn5w
It the same with the card installed or without, this is also my only one or I thought of trying to make a card with the firmware and trying and boot it that way?
Anyone have any ideas? or is this now a $10,000 paperweight
Next I am going to try an enbt to see if I can go in that route but the USB is dead
It looks like they tried to flash it but something went wrong, see this video of it
I was going to try and re-flash it but now the comms will not work either, anyone seen this before?
Cycle power to unit: Assert in file S:/LNX/NetlinxUCS/NcsSrc/CommPorts/NcsLinkLayer.cpp Line 489
Here is the video https://www.youtube.com/watch?v=GWbV7d-Sn5w
It the same with the card installed or without, this is also my only one or I thought of trying to make a card with the firmware and trying and boot it that way?
Anyone have any ideas? or is this now a $10,000 paperweight
Next I am going to try an enbt to see if I can go in that route but the USB is dead