Hi friends,
I am beginner in PLC programming.
Presently I am facing problem at my workplace,where no one to solve this.I have theoretical knowledge but not practical.
My problem?
1)How to connect 2 wire pressure transducer to S7 431-1KF10 8x14bit Analog module?
2)Where to connect Pin number of L+(+24) and M(-24).Dont show me manual,because i am confuse about which it is showing, 3 or 4 and 47 or 48?
3)Is 2 wire transducer should connect directly to input pins or in series with 24 dc supply to give current to pins?
4) How to take this current variation on WinCC scada
I will be very happy if someone show me this by their diagram not manual.
Please help me.
I am beginner in PLC programming.
Presently I am facing problem at my workplace,where no one to solve this.I have theoretical knowledge but not practical.
My problem?
1)How to connect 2 wire pressure transducer to S7 431-1KF10 8x14bit Analog module?
2)Where to connect Pin number of L+(+24) and M(-24).Dont show me manual,because i am confuse about which it is showing, 3 or 4 and 47 or 48?
3)Is 2 wire transducer should connect directly to input pins or in series with 24 dc supply to give current to pins?
4) How to take this current variation on WinCC scada
I will be very happy if someone show me this by their diagram not manual.
Please help me.