Hi guys,
I have a Metler Toledo M800 that will be used to read mainly my ph and conductivity sensor on my system, i saw on the terminal block i have a Analog out ( A1out+) abd (A1out-) i would like to use to my control logix. im planning to use a Point I/O 1734-IE4C ( current analog input ). but was wondering how im suposed to connect it correctly ? do i have to put a 24vdc on my 1734-IE4C module ? current analog like this is 2 wire right ? im not doing it very often and its my first time using Point IO.
In total i have 4 analog current 4-20ma going out of my metler to put to the 1734-IE4C module.
I have a Metler Toledo M800 that will be used to read mainly my ph and conductivity sensor on my system, i saw on the terminal block i have a Analog out ( A1out+) abd (A1out-) i would like to use to my control logix. im planning to use a Point I/O 1734-IE4C ( current analog input ). but was wondering how im suposed to connect it correctly ? do i have to put a 24vdc on my 1734-IE4C module ? current analog like this is 2 wire right ? im not doing it very often and its my first time using Point IO.
In total i have 4 analog current 4-20ma going out of my metler to put to the 1734-IE4C module.
