842D DeviceNet Multi-Turn Encoder

[TomekPLC]

Hello everyone,
I wanted to change/reset the position value of the above encoder. I have RSNetWorx for DeviceNet and RSLogix5000.
What is the function of the push button inside of the encoder?
Maybe someone has good link to the manual. I was only able to find this: http://literature.rockwellautomatio...0020&FamilyId=2836&passedLangVal=EN - English

Thanks,
Tom

 

[JERA]

The manual for the encoder:
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/842d-um001_-en-p.pdf

The function of the push button inside of the encode is a preset function. Read page 17 in the pdf file (page 3-3 i manual)

 

[TomekPLC]

JERA,
Thank you for help.
Tom

 

[paar1]

842D DeviceNet Multi-Turn Encoder

How is a loss of signal indicated to the PLC (ControLogix)? I had a devicenet cable break recently and wanted to know how to sense that and respond accordingly. Thanks.

 

[sthompson]

842D DeviceNet Multi-Turn Encoder

How is a loss of signal indicated to the PLC (ControLogix)? I had a devicenet cable break recently and wanted to know how to sense that and respond accordingly. Thanks.

Have a look at Chapter 7 of this Manual.

http://literature.rockwellautomation.com/idc/groups/literature/documents/um/dnet-um004_-en-p.pdf

Also, have a look at the Status Tags for your DNB Card.

Stu....