robcontec
Member
looked through the other threads on this topic, but didn't see what I am looking for.
I have several 1305's running a conveyor system.
They are on an RIO network using 1203-GD1s
Who ever wrote the code and wired configured the drives must of had issues that now I have to live with (hopefully only for a short peroid)
Anyhow all the drives are running in jog mode
The drive is configured 3 wire control
Adapter 1 as the freq source.
The 1203 is plugged into what is Adapter 2
But if I change everything to adapter 2 I get the same results
If I understand the manual and I'm not sure that I do on pg 5-29 5-30 I believe I need to add a jumper from term 15 to term 18, but the manual to me atleast is as clear as mud
Any help would be greatly appreciated since I'll have to change about 30 of these things
I have several 1305's running a conveyor system.
They are on an RIO network using 1203-GD1s
Who ever wrote the code and wired configured the drives must of had issues that now I have to live with (hopefully only for a short peroid)
Anyhow all the drives are running in jog mode
The drive is configured 3 wire control
Adapter 1 as the freq source.
The 1203 is plugged into what is Adapter 2
But if I change everything to adapter 2 I get the same results
If I understand the manual and I'm not sure that I do on pg 5-29 5-30 I believe I need to add a jumper from term 15 to term 18, but the manual to me atleast is as clear as mud
Any help would be greatly appreciated since I'll have to change about 30 of these things