Hey guys, I am using ML1200 with Analog module IF4. When i apply voltage (0-10V) across Terminals of Analog module i am getting wrong value on SCP instruction.
Consider, voltage across terminal is 3.38V but i am getting following values on PLC.
>> I:1/2 = 2245
SCP settings:
>> Input Min = 0
>> Input Max = 31206
>> Scaled Max = 100
>> Scaled Min = 0
>> Output = 7
Input switches are in Voltage position
Thanks
Consider, voltage across terminal is 3.38V but i am getting following values on PLC.
>> I:1/2 = 2245
SCP settings:
>> Input Min = 0
>> Input Max = 31206
>> Scaled Max = 100
>> Scaled Min = 0
>> Output = 7
Input switches are in Voltage position
Thanks