Automation Direct to Robicon Drive

Jeff D

Member
J
Join Date
May 2006
Location
Illinois
Posts
20
I am using a DL260 to control 2 Robicon VFD's. I have a H2-ECOM100 going to a switch going to each Sixnet EtherTrak in the VFD. They are talking Modbus and I can see Modbus activity going to the Sixnet modules but I'm not getting the speed setpoint or run commands to or from the drives. Any ideas on what to do?

Thanks, Jeff
 

Similar Topics

R
Automation direct DL206 (d2 262 plc) and HMI EA9T6CL-R - set date and time through HMI
Hello, I have an automation direct d2 262 plc and C-more HMI EA9T6CL-R. I need to prepare a program, scheduled to be performed on a future date. I...
Replies
1
Views
137
tarik1978
T
B
peak voltage detector Automation direct 06
Hello all- I have a unique challenge using a customers Direct logic 06 PLC. This customer has a DC motor operating at 10 RPM which is turning a...
Replies
1
Views
142
drbitboy
drbitboy
M
Command over Ethernet/IP (Sysmac Studio and Automation direct GS20)
Hi, I have been trying to run drive via Sysmac studio. I can ping the drive. I can see the logic bits going on/off as per command. But, drive is...
2
Replies
21
Views
577
tarik1978
T
D
Automation Direct CM5 HMI Review
Anyone tried Automation Directs new CM5 HMI. We've been the EA9's for a few years now with minimal complaints. A few failures here and there but...
2
Replies
17
Views
1,605
Rsflipflop256
Rsflipflop256
C
Question re: need for line side contactor for an Automation Direct GS20 VFD?
I'm using an Automation Direct GS20 VFD for the first time and I have a question for the Automation Direct gurus regarding the recommendation of a...
Replies
2
Views
1,105
ControlSysNick
C
Back
Top Bottom