Micrologix 1400 reading an anderson flow meter. HSC is used to detect flow. Meter set to 1000 pulses per HL. I need to display the flow rate on an AB Panelview 550 HMI. The flowmeter was connected using a converted 4-20mA signal and displayed flow in the HMI. No HMI programming is needed. This was not as accurate as was required. My volume count is good I just dont know how to build the logic required to find the average pulse count in say; HL/minute. Im sure this is easy for you guys!
Thanks
Tanner
GWB elec/inst.
Thanks
Tanner
GWB elec/inst.