Hey guys,
On my system, i got prop valve controling cylinder on the left and right to adjust the center of a lumber before it get in a woodmill. One the picture i linked, you can see the 2nd AxisXY got a physicalAxisFault and FeedbackFault.
These valve work on a 0-10VDC analog output.
The way we found this out, we tried to move it in manual with my mechanic guy and couldnt move it, when i check what is stopping me to do it, i'm missing the AxisXY_LHS_OF.ServoActionStatus condition to make it work in manual.
We use temposonic on these cylinder to read the distance. The mechanic told me they disconnected all the temposonic to make some test and put them back after, i was wondering what i could do or if you guys had any idea what kind of problem this could be.
I'm asking around to see if you one of guys had any idea before i call someone that know this much more than me!
Thanks
On my system, i got prop valve controling cylinder on the left and right to adjust the center of a lumber before it get in a woodmill. One the picture i linked, you can see the 2nd AxisXY got a physicalAxisFault and FeedbackFault.
These valve work on a 0-10VDC analog output.
The way we found this out, we tried to move it in manual with my mechanic guy and couldnt move it, when i check what is stopping me to do it, i'm missing the AxisXY_LHS_OF.ServoActionStatus condition to make it work in manual.
We use temposonic on these cylinder to read the distance. The mechanic told me they disconnected all the temposonic to make some test and put them back after, i was wondering what i could do or if you guys had any idea what kind of problem this could be.
I'm asking around to see if you one of guys had any idea before i call someone that know this much more than me!
Thanks