davinch
Guest
D
Thanx to btalbot,tomjenkins and sid for responding. Please let me take this one step at a time as i am a novice. I have the toshiba expdd software loaded and i have the cutler hammer rs232 adapter. But first things first. I have opened a ladder diagram blank and written an x000 input with a y000 output do i then need to write the end instruction. I have gone to the next line an put an end in but when i hit f10 to accept i get a (005) inactive key response. I have no clue as where to go from here. I know you guys are busy and if you dont have the time to respond perhaps you could point me to a reference that would get me started. If i could just get going with the instructions for a simple one line program get it accepted and saved and then get it to the plc to run i can get the rest by myself. Thanx again
Dave
Hey btalbot although i now live in western pa i was born and raised in trenton!
Dave
Hey btalbot although i now live in western pa i was born and raised in trenton!