James Ross
Member
Hi everyone
We have a DKC11.3-040-7-FW with FWA-ECODR3-SGP-01VRS-MS firmware on programming module.
Whenever we try to calculate commutation offset via DriveTop software, face with a D301: drive not ready for commutation command.
According to user manual the remedy is to activate torque mode, but we have activated torque mode already.
Is this something about the firmware version, or we need something more?
Best regards
We have a DKC11.3-040-7-FW with FWA-ECODR3-SGP-01VRS-MS firmware on programming module.
Whenever we try to calculate commutation offset via DriveTop software, face with a D301: drive not ready for commutation command.
According to user manual the remedy is to activate torque mode, but we have activated torque mode already.
Is this something about the firmware version, or we need something more?
Best regards