Hi,
I am in a process of replacing 1330 PLUS drive to powerflex 70 drive. the existing drive is connected via DeviceNet. In the IO configuration I can see 4Bytes of input data and 4Bytes of output data. first word (Word 0) of Input gives me the status of logic. Second word (Word 1) gives me the value of FEEDBACK. First word (Word 0)of output takes the command (start/ stop) from PLC.Second word (Word 1) is reference (set point) value.
The question is Input word2 which is the feedback, currently I am reading the actual Motor current in amps. if i have to read motor voltage, where do i have to configure?
Thanks in advance
I am in a process of replacing 1330 PLUS drive to powerflex 70 drive. the existing drive is connected via DeviceNet. In the IO configuration I can see 4Bytes of input data and 4Bytes of output data. first word (Word 0) of Input gives me the status of logic. Second word (Word 1) gives me the value of FEEDBACK. First word (Word 0)of output takes the command (start/ stop) from PLC.Second word (Word 1) is reference (set point) value.
The question is Input word2 which is the feedback, currently I am reading the actual Motor current in amps. if i have to read motor voltage, where do i have to configure?
Thanks in advance