DeviceNet DaisyChain

Jmeadows7676

Member
Join Date
Oct 2013
Location
Alabama
Posts
158
Hello,

I was wondering if anyone knows if it will be ok to have a DeviceNet Daisy Chain with the Nodes not in order.
Example: Scanner Node 0 going to node 7 then to node 6 then to node 5.
Does anyone see a problem with this.


Thanks,
 
Hello,

I was wondering if anyone knows if it will be ok to have a DeviceNet Daisy Chain with the Nodes not in order.
Example: Scanner Node 0 going to node 7 then to node 6 then to node 5.
Does anyone see a problem with this.


Thanks,


I've never had any issues with nodes out of order. Once they are all found it should be good.
 
It's physically a parallel signal bus, so every device sees every transmission at the same time on the wire.

As pattern-recognizing humans we love to see things in sequence, but it does not matter at all to the DeviceNet network devices.
 

Similar Topics

Hi. We've been asked to do an upgrade on plant, consisting on a PLC upgrade. This involves replacing a 1747-SDN module to a 1769-SDN, in a network...
Replies
0
Views
44
Hi there, I have above mentioned VFD which is communicating to my control logix(L62) plc using devicenet DNB scanner(plc side) and 20-comm-D card...
Replies
3
Views
143
Hi, I am looking to migrate some of our Electronic Overloads off of a Troublesome Devicenet Segment. Is there any documentation confirming the...
Replies
5
Views
141
We've run into an old system that we are upgrading which is still running Steeplechase with Citect using Devicenet to Wago. I had some experience...
Replies
4
Views
164
Sigh, DeviceNet noob... I have a 1756-L55, with a DeviceNet module, and 10 PF700 all commanded with DeviceNet. One of the PF700's blew up...
Replies
3
Views
150
Back
Top Bottom