Hi, I have PanelViev 1000 grayscale and SLC5/03. I run SCADA via ethernet bridge that is connected to SLC5/03 via RS232. The PanelView is connected with PLC via DH485. I run out of ports to connect another ethernet bridge to PLC so I can modify PLC online, but on HMI there is one DH485 (RJ45) port that I use to connect PC via 1747-UIC. Due to the need of some changes every now and then I would like to use PanelView DH485 (R45) port to connect it to the ethernet bridge so I can access PLC and HMI from control room.
I was thinking about 1747-UIC usb to DB9 conversion and connect it with the ethernet bridge, but I am not sure will it work.
So my question is: Is there any way of connecting DH485 (RJ45) to the network so I can access it via ethernet bridge software virtual port or any other way?
Thanks for help
I was thinking about 1747-UIC usb to DB9 conversion and connect it with the ethernet bridge, but I am not sure will it work.
So my question is: Is there any way of connecting DH485 (RJ45) to the network so I can access it via ethernet bridge software virtual port or any other way?
Thanks for help
Last edited: