buddhaman001
Member
So i have a scada system, of course, and it is doing a most odd thing.
So we are monitoring fine blah blah blah then for some reason be it bandwidth or connection issues (unsure at this point) quite a few of our digital tags go to an error state, understandable if there is indeed an error....but they stay that way until the software is restarted.
Shouldn't factorytalk attempt to refresh the data anyway? or is there a setting that ive missed.
also this is not replicatable, and happens at seemingly random intervals, could happen once a week could happen once a month or not at all. also our analog values seem to be unaffected even if EVERY digital bit being monitored for a certain site goes into error, but usually it is only one or two bits that go to error at a given time, usually our softstart motors sometimes our power monitor.
what gives plctalk?
So we are monitoring fine blah blah blah then for some reason be it bandwidth or connection issues (unsure at this point) quite a few of our digital tags go to an error state, understandable if there is indeed an error....but they stay that way until the software is restarted.
Shouldn't factorytalk attempt to refresh the data anyway? or is there a setting that ive missed.
also this is not replicatable, and happens at seemingly random intervals, could happen once a week could happen once a month or not at all. also our analog values seem to be unaffected even if EVERY digital bit being monitored for a certain site goes into error, but usually it is only one or two bits that go to error at a given time, usually our softstart motors sometimes our power monitor.
what gives plctalk?