Downloading to eeprom

[baler]

Hi! I'm using RsLogix 500, version 7.30.00(CPR9).
I get error:"Download to eeprom failed. 0x4", any time that I try such function. Any suggestion. Thank you very much. Miguel.

 

[Bob O]

Is there an eeprom installed?

 

[baler]

Yes, There is one. It happens with any processor that I tried.

 

[Mickey]

Maybe some help at link below

http://rockwellautomation.custhelp....WVwcm9tIGZhaWxlZC4gMHg0Ig**&p_li=&p_topview=1

 

[baler]

Thank you a lot,Mickey.

 

[Mickey]

Thank you a lot,Mickey.

Your Welcome.

 

[Tim Ledwith]

I had a similar problem, the EEPROM was actually been burnt OK. It only happened when accessing the PLC's through multiple network bridges.

 

[Spinjack]

Maybe some help at link below

http://rockwellautomation.custhelp....WVwcm9tIGZhaWxlZC4gMHg0Ig**&p_li=&p_topview=1

Is there another way to reach this KB entry? I'm having the same problem but my RS tech support is long expired.

 

[JaxGTO]

Is there another way to reach this KB entry? I'm having the same problem but my RS tech support is long expired.

It basically says there was a network timeout, but it actually writes the EEPROM ok. Says to verify using restore from EEPROM and verifying the program.
I have also found you can prevent this error when setting up the comms to increase the timeout to 30 seconds.