How to configure the DPRD_DAT and also DPWR_DAT if the slave is non siemens I/O and does not have any hardware ID(system constants) and just the profibus address and input output area .
Wago slave has the Input address 7 to 16 and output from 7 to 11. It has a Profibus address of 40
I have to get 10 bytes from this Wago slave device to the S7-1200 CPU
so how i configure the DPRD for this
from siemens help on DPRD_DAT
"LADDR = Hardware ID of the module from which the data is to be read.
The hardware ID can be found in the properties of the module in the device view or system constants."
Wago has no hardware ID
Wago slave has the Input address 7 to 16 and output from 7 to 11. It has a Profibus address of 40
I have to get 10 bytes from this Wago slave device to the S7-1200 CPU
so how i configure the DPRD for this
from siemens help on DPRD_DAT
"LADDR = Hardware ID of the module from which the data is to be read.
The hardware ID can be found in the properties of the module in the device view or system constants."
Wago has no hardware ID
Last edited: