theColonel26
Lifetime Supporting Member
My base address all work fine. The problem starts when I set the Index from 0 to an offset. I get a "PLC No Response" error.
So say my Base address is B10:2/5
In maple that address is 01000205
What if I want to access B20:2/5
Would that offset be 10,000 or would it be 1,000,000? the Manual says that offsets for bits are still by words, so I would think the offset would be 10,000 I have tried both. I get a "PLC No Response" error with both.
if I assign If I set it to use Index 16, and set index 16 to 10,000 I would expect to get B20:2/5
Same for words if it was F15:4 and I wanted F25:4 I would set the index to 10,000 and if I wanted F35:4 I would set the index to 20,000 as 015,004 + 20,000 = 35,004
and N at the Bit level N13:2/8 to get N42:2/8 I would need to use 30,000.
What am I doing wrong?
So say my Base address is B10:2/5
In maple that address is 01000205
What if I want to access B20:2/5
Would that offset be 10,000 or would it be 1,000,000? the Manual says that offsets for bits are still by words, so I would think the offset would be 10,000 I have tried both. I get a "PLC No Response" error with both.
if I assign If I set it to use Index 16, and set index 16 to 10,000 I would expect to get B20:2/5
Same for words if it was F15:4 and I wanted F25:4 I would set the index to 10,000 and if I wanted F35:4 I would set the index to 20,000 as 015,004 + 20,000 = 35,004
and N at the Bit level N13:2/8 to get N42:2/8 I would need to use 30,000.
What am I doing wrong?