I am trying to setup a Fault Active bit in my logic.
I have a range of faults roughly 0 to 500 (bits). I would like to have one instruction to compare/add all the results. If all bits are not equal to zero or all them added together is not equal to zero I know I have a fault on.
I do this in RSlogix via FBC however that instruction has a Found ouput (FD). Is there anything like that in GX Works?
Thanks
I have a range of faults roughly 0 to 500 (bits). I would like to have one instruction to compare/add all the results. If all bits are not equal to zero or all them added together is not equal to zero I know I have a fault on.
I do this in RSlogix via FBC however that instruction has a Found ouput (FD). Is there anything like that in GX Works?
Thanks