NR16
Member
I have restored a crashed IFIX to a new PC. The restore is ok and installed GE9 driver. With the GE9 power tools, we can observed that data transmits and recieve.
The problem is that the screen scada is not updating i.e. no status/feedback, anything is happening.
The LAN network TCP/IP was configured i.e. IP, subnet and gateway.
Any remedies/advice is most welcome. Please provide a guide on the communication/configuration setup.
Thanks
The problem is that the screen scada is not updating i.e. no status/feedback, anything is happening.
The LAN network TCP/IP was configured i.e. IP, subnet and gateway.
Any remedies/advice is most welcome. Please provide a guide on the communication/configuration setup.
Thanks