I'm sorry to bother you guys,
I have been battling this random issue for weeks. We have 14 - Kinetix 6000 drives. When the operator sometimes stops the machine , all 14 drives fault out with E-38 Faults. The only way to reset these faults is to power down the machine . Once the operator resets the machine to run it , one servo motor takes off at a high rate of speed. The machine is about 10 years old and nobody has seen this happen. I don't know much about motion ( I want to learn more ) . We replaced all the Fiber Optic Cables. The only thing left would be the Serco's Module 1756-M16SE.
Have any of you seen this before ?
Thanks again,
I have been battling this random issue for weeks. We have 14 - Kinetix 6000 drives. When the operator sometimes stops the machine , all 14 drives fault out with E-38 Faults. The only way to reset these faults is to power down the machine . Once the operator resets the machine to run it , one servo motor takes off at a high rate of speed. The machine is about 10 years old and nobody has seen this happen. I don't know much about motion ( I want to learn more ) . We replaced all the Fiber Optic Cables. The only thing left would be the Serco's Module 1756-M16SE.
Have any of you seen this before ?
Thanks again,