Hello,
This is my very first post here - I'm working on a small brewery project with multiple solenoid valves.
The instructions follow a set of commands
Step 1: Valve 1 opens,
Step 2: Valve 2 closes after a delay
Step 3: etc.
Step 4: etc.
Basically, I have the program working up until I need to repeat a rinse cycle (this is for a keg wash) - my program is divided into subroutines, but after it runs once, I need to re-run steps 2-4 a second time.
How do I implement a logic in RSLogix5000 that allows me to "re-use" the previous routines. They all have timers that are TON's, and am trying to find a way to "clear" what has been done before to re-use these subroutines as if it was a fresh start.
Thanks for your help.
~ Lumi
This is my very first post here - I'm working on a small brewery project with multiple solenoid valves.
The instructions follow a set of commands
Step 1: Valve 1 opens,
Step 2: Valve 2 closes after a delay
Step 3: etc.
Step 4: etc.
Basically, I have the program working up until I need to repeat a rinse cycle (this is for a keg wash) - my program is divided into subroutines, but after it runs once, I need to re-run steps 2-4 a second time.
How do I implement a logic in RSLogix5000 that allows me to "re-use" the previous routines. They all have timers that are TON's, and am trying to find a way to "clear" what has been done before to re-use these subroutines as if it was a fresh start.
Thanks for your help.
~ Lumi