MauritsKoppe
Member
Hello,
I am using a AB Micro820 PLC, via the SD card I want to update the PLC program (not FW).
First I created a text file on the SD card with the name ConfigMeFirst.txt, to backup the program from another 820.
Then changed the ConfigMeFirst.txt with:
[IPA = 192.168.1.40]
[SNM = 255.255.255.0]
[GWA = 192.168.1.1]
[RSD = Micro820QWB]
[END]
Inserted the SD card into a new 820. I do believe the programming was done correctly.
My problem is that the 820 stay in Program Mode. Even after several power cycles the green Run led stays blinking indicating that the unit is in ProgramMode.
It did change the IP address from default to the above.
How to get the 820 in Run Mode again?
Thank you.
I am using a AB Micro820 PLC, via the SD card I want to update the PLC program (not FW).
First I created a text file on the SD card with the name ConfigMeFirst.txt, to backup the program from another 820.
Then changed the ConfigMeFirst.txt with:
[IPA = 192.168.1.40]
[SNM = 255.255.255.0]
[GWA = 192.168.1.1]
[RSD = Micro820QWB]
[END]
Inserted the SD card into a new 820. I do believe the programming was done correctly.
My problem is that the 820 stay in Program Mode. Even after several power cycles the green Run led stays blinking indicating that the unit is in ProgramMode.
It did change the IP address from default to the above.
How to get the 820 in Run Mode again?
Thank you.