move some mm

Circiter

Member
C
Join Date
Oct 2023
Location
Belgium
Posts
23
hi,

I got a plc S7-1200 with SEW movitrac **** and i need to program something ridiculous

if my application reaches sensor 1 then my SEW has to move x amount of mm's according to what the operator selects on the HMI.

if my application reaches sensor 1 again after the cycle, my sew has to move an x amount of mm's again.

after 5 cycles the SEW has to go back to its original start position.

anyone has an idea how to program this ****?

thanks
 

Similar Topics

V
Micro850 + Sensor: 1 Axis can not move in negative direction when working together with sensor
Hi everyone, I am working with micro850, a proximity sensor (FOTEK, PL-05P) and a 3DOF serial arm robot. I use MC_MoveRelative to control the...
Replies
1
Views
62
vhs
V
T
Control Valve won't move
So I'm pretty green when it comes to troubleshooting in the field so bear with me. We have a Danfoss valve that opens/closes from an analog output...
2
Replies
23
Views
959
arpus4KM
A
dalporto
Rockwell Move Float to specific INT arrays
Hi. This is pretty basic but I'm struggling to find an efficient solution. I have a float value of let say 666.555 that I want to move / split...
Replies
3
Views
212
joseph_e2
J
M
TIA Portal Move Data From An Optimised Block
Afternoon, I have a DB in TIA Portal V16 that is optimised. I cannot change this. There is an array inside that block which consists of 3000...
Replies
9
Views
1,154
mk42
M
P
Stop Servo Move on Torque Limit
Hello, I am working on an application that inserts a splined shaft into a 'gearbox'. The shaft is rotating slightly to allow engagement of the...
Replies
8
Views
1,282
plccontrols
P
Back
Top Bottom