hi,
I got a plc S7-1200 with SEW movitrac **** and i need to program something ridiculous
if my application reaches sensor 1 then my SEW has to move x amount of mm's according to what the operator selects on the HMI.
if my application reaches sensor 1 again after the cycle, my sew has to move an x amount of mm's again.
after 5 cycles the SEW has to go back to its original start position.
anyone has an idea how to program this ****?
thanks
I got a plc S7-1200 with SEW movitrac **** and i need to program something ridiculous
if my application reaches sensor 1 then my SEW has to move x amount of mm's according to what the operator selects on the HMI.
if my application reaches sensor 1 again after the cycle, my sew has to move an x amount of mm's again.
after 5 cycles the SEW has to go back to its original start position.
anyone has an idea how to program this ****?
thanks