Jeroen Benoot
Member
Hi all,
I had a Siemens Scalance S602 setup in the past that worked fine.
But these are obsolete now and replaced by a Scalance SC632-2C.
The only function I use it for is for NAT (Network address translation).
However in the new SC632-2C the config is slightly different and I can't seem to figure out how to correctly configure it.
The basic function it has to do is:
CPU IP: 192.168.1.1 in machine network
Scalance must translate this to 10.21.40.50 in IT network.
Anyone has any experience with this?
thanks!
I had a Siemens Scalance S602 setup in the past that worked fine.
But these are obsolete now and replaced by a Scalance SC632-2C.
The only function I use it for is for NAT (Network address translation).
However in the new SC632-2C the config is slightly different and I can't seem to figure out how to correctly configure it.
The basic function it has to do is:
CPU IP: 192.168.1.1 in machine network
Scalance must translate this to 10.21.40.50 in IT network.
Anyone has any experience with this?
thanks!