BigJon1023
Member
I have a setup with:
PLC1
PLC2 connected serially (only option) to Quick Panel.
I wish to use EGD to read/write from PLC1-PLC2 so I can use the quickpanel to control PLC1.
My question with EGD is how to do you keep it from reading/writing over itself.
Meaning if %R1 = 1 on PLC1 and %R1 = 2 on PLC2 depending on which it gets to first will change %R1 and ignore the other.
PLC1
PLC2 connected serially (only option) to Quick Panel.
I wish to use EGD to read/write from PLC1-PLC2 so I can use the quickpanel to control PLC1.
My question with EGD is how to do you keep it from reading/writing over itself.
Meaning if %R1 = 1 on PLC1 and %R1 = 2 on PLC2 depending on which it gets to first will change %R1 and ignore the other.