Oil terminal training for smith meters and acculoads

hugh maloney

Member
H
Join Date
Dec 2005
Location
dublin
Posts
9
Hello fellas,


Can anybody tell me if they have done training in any of the following with FMC Technologies:
Smith Meter® AccuLoad III
Smith Meter® AccuLoad III - Advanced
Terminal/Loading Rack
If you have could you tell me how you found the training; was it any good?
The background on this is that im now working with these systems and i want to get to know them inside out for calibration, installation, uypgrade purposes etc.

Thanks.
 

Similar Topics

P
GX Works2 Output and Coil not working
Hello to all, is my first post on the forum, I searched everywhere, but I could not find an answer to this problem; I am quite experienced in...
Replies
13
Views
999
parky
P
S
Studio 5000 Latch Coil does signal pass thru
So I'm having issues with a certain rung and one of my coworkers mentioned it may not allow the signal past the latch coil. For example in the...
2
Replies
27
Views
3,767
I_Automation
I_Automation
A
Vijeo Citect 7.4 error reading Coil Register Address
I need help with vijeo citect 7.4 as I use Modbus TCPIP to get the data, it turns out the address is having error.. For example, when I write...
Replies
2
Views
898
Aimin Ariff
A
I_Automation
Dual Coil Relay?
I thought of this before and always did like everyone else and put 2 relays next to each other and wire the contacts parallel, but... Has anyone...
Replies
2
Views
1,192
I_Automation
I_Automation
J
Codesys 2.3 Wago 750-881 Modbus setup suggestions for fancoil control
Hi, I have never used modbus communication in Codesys 2.3, any tips and tricks are much appreciated. The system is a Wago 750-881 that controls...
Replies
3
Views
1,870
drbitboy
drbitboy
Back
Top Bottom