I am trying to set up a PV+ 1000 to monitor plant wide processes.
I am not having any trouble setting up the Control Logix and SLCs that I have on the ethernet network.
However, I have one line that had several SLCs already connected to each other thru DH+. I added a 7 slot control logix rack an ENBT, and a DHRIO card. I can now communicate to all my PLCs in RSLINX. When I try to set up the comms in RSLINX Enterprise in RSView Studio, all I get is the ? followed by Bus. For some reason it seems Linx Enterprise does not see anything past the control logix bridge that I have set up.
Am I missing something or is this a limitation in Linx Enterprise, or is there a work around other than dropping ENIs on all my PLCs.
I am not having any trouble setting up the Control Logix and SLCs that I have on the ethernet network.
However, I have one line that had several SLCs already connected to each other thru DH+. I added a 7 slot control logix rack an ENBT, and a DHRIO card. I can now communicate to all my PLCs in RSLINX. When I try to set up the comms in RSLINX Enterprise in RSView Studio, all I get is the ? followed by Bus. For some reason it seems Linx Enterprise does not see anything past the control logix bridge that I have set up.
Am I missing something or is this a limitation in Linx Enterprise, or is there a work around other than dropping ENIs on all my PLCs.