Good Morning,
This may be an easy question for some...but I'll need a little guidance.
I have a project where under a particular condition I will need to force a PCV normally controlled by a PID loop to 15% open.
Under any other circumstances, the loop will control the valve.
Is there a good, clean way to do this? I guess I could think of a couple ideas, but they are not real clean in my opinion.
Thanks,
Burch
This may be an easy question for some...but I'll need a little guidance.
I have a project where under a particular condition I will need to force a PCV normally controlled by a PID loop to 15% open.
Under any other circumstances, the loop will control the valve.
Is there a good, clean way to do this? I guess I could think of a couple ideas, but they are not real clean in my opinion.
Thanks,
Burch