rwy34ils
Member
I am installing DirectSoft Ver 5 (Direct Logic) in my new laptop. When I go to set up the communications link between the laptop and the PLC, the list only shows COM 1 and COM 2 as available choices for serial communications. My old laptop shows COM 1 to 4.
I am using the same installation CD as I used for the old laptop.
Has anyone seen this before? I need to use COM 4 with the new PC. COM 4 is listed in the Windows hardware device manager on the new computer.
I am using the same installation CD as I used for the old laptop.
Has anyone seen this before? I need to use COM 4 with the new PC. COM 4 is listed in the Windows hardware device manager on the new computer.
Last edited: