captain_fracasse
Member
Hello all,
My problem is that I need to send a max current value into a Danfoss FC302 using the profinet communication. Not so complicated normally but when I try to configure the drive using the Danfoss GSD file there's all the PPO except PPO1, PPO2 and PPO5 that means no possibility to send any information into the drive!!!!
People from Danfoss suggest us to control the current into our PLC but... I'd like to know if somebody has another idea.
It's amazing because all PPO configurations exist in Profibus!!!
Thanks!
My problem is that I need to send a max current value into a Danfoss FC302 using the profinet communication. Not so complicated normally but when I try to configure the drive using the Danfoss GSD file there's all the PPO except PPO1, PPO2 and PPO5 that means no possibility to send any information into the drive!!!!
People from Danfoss suggest us to control the current into our PLC but... I'd like to know if somebody has another idea.
It's amazing because all PPO configurations exist in Profibus!!!
Thanks!