Hi, we have a bad output on a SM-332 analog output module that controls a modulator on our oven. Since this plant uses primarily AB PLC's I have very little knowledge on Siemens.
My question is, can I power down the PLC and take my spare SM332 card and just swap it out with the new card and be off and running again or will I have to download the program to the card or is there another procedure??
I will have about an hour next week when I can power down the PLC so I want to be as prepared as possible. I looked through the SM 332 manual and searched the web and haven't found an answer yet. I am sure this is common knowledge for the Siemens gurus here.
Thanks for the help!
My question is, can I power down the PLC and take my spare SM332 card and just swap it out with the new card and be off and running again or will I have to download the program to the card or is there another procedure??
I will have about an hour next week when I can power down the PLC so I want to be as prepared as possible. I looked through the SM 332 manual and searched the web and haven't found an answer yet. I am sure this is common knowledge for the Siemens gurus here.
Thanks for the help!