Jethro Baidoo
Member
I want to read voltage and current from a Danfoss drive FC300 with S7-300 PLC.
I need help with the programming. Hardware bit has been done by OEM.
I need help with the programming. Hardware bit has been done by OEM.
I want to read voltage and current from a Danfoss drive FC300 with S7-300 PLC.
I need help with the programming. Hardware bit has been done by OEM.
I understand. But my question is since the first 2 PCDs(1 and 2) are reserved should I assume they automatically occupy PIW660 and PIW662 and that PCD3 will occupy PIW664?
+1But there’s probably an sfc14/15 that reads and writes to a data block
(Already in your program)