SCL for ControlLogix 5000

[Patrick]

If I enter the reverse values in the SCL parameters would the output be reverse? In other words, if I enter 0 into InRawMax and 16383 into InRawMin Would the output signal be reversed. Or is that what the InRawRangeInv is for? Not getting too far with the manual. It makes the InRawRangeInv sound like a status or error message.



It seems like I had read, on this board or another that you could switch these values and it would work.



Thank you

Pat

 

[ttichy]

I believe the RawMin has to be < RawMax. To reverse output, switch the EU parameters instead

 

[Patrick]

Thank you ttichy. I was finally able to get on line with one of the controllers to verify this. It is the EU values that are reversed.

Pat