Hi everyone,
I'm trying to perform a serial download with a Total Control Quickpanel jr (QPK-2xxxx) using an old computer running QuickDesigner 3.7. I have the cable pluged into the Tool port of the Quickpanel jr and the other end into the single comm port of the computer. I have the correct model selected in the QuickDesigner application, port is set to RS232C at 9600 baud and I presume that PLC can be set to <No Protocol>. When I attempt to initiate the serial download, it looks like it is about to start but then fails with the error message "There are no panels defined for this project!".
I've also changed the baud rate in the courier.ini file from 38400 to 9600 but it still doesn't work.
Would anyone have any suggestions on what I have failed to do or anything else I should try, please?
Thanks in advance.
I'm trying to perform a serial download with a Total Control Quickpanel jr (QPK-2xxxx) using an old computer running QuickDesigner 3.7. I have the cable pluged into the Tool port of the Quickpanel jr and the other end into the single comm port of the computer. I have the correct model selected in the QuickDesigner application, port is set to RS232C at 9600 baud and I presume that PLC can be set to <No Protocol>. When I attempt to initiate the serial download, it looks like it is about to start but then fails with the error message "There are no panels defined for this project!".
I've also changed the baud rate in the courier.ini file from 38400 to 9600 but it still doesn't work.
Would anyone have any suggestions on what I have failed to do or anything else I should try, please?
Thanks in advance.