nileshsurya
Member
hi thr u all plc experts
recently i came across with 2-3 SLC systems in which one typical problem was there
when the SLC is cycle powered it directly goes into fault mode,it should go into run mode but it doesnt.it is then bought into run mode by switching the key
what must be the probable cause for this and what is the suggested remedy, can anybody tell plz
can the status bit fault override at powerup be set to solve this problem
i am also desperatley looking for the probable cause of this problem
waiting for reply ASAP
regards
NileshSURYA
recently i came across with 2-3 SLC systems in which one typical problem was there
when the SLC is cycle powered it directly goes into fault mode,it should go into run mode but it doesnt.it is then bought into run mode by switching the key
what must be the probable cause for this and what is the suggested remedy, can anybody tell plz
can the status bit fault override at powerup be set to solve this problem
i am also desperatley looking for the probable cause of this problem
waiting for reply ASAP
regards
NileshSURYA