Hello Friends
I have followed the quick start to configure my NAT access, I have done a lot of tries but without sucess.
I am attaching the drawing of my network.
What I want to do, is to access the PLC from the Server PC.
So, I have configured the General and Public to Private tabs as in the image.
I just have Gi1/1 1(native lan) where is connected the Server PC
Smartports, all to none, just Gi1/1 as Switch for automation
Port settings, all to autonegotiate and administrative mode to dynamic auto, just Gi1/1 as trunk.
With this configuration, I try to do a ping from Server PC to the PLC (192.168.190.1 Public addres for the PLC) but this not responds.
which could be the problem?
I am doing a lot of tries but not working.
Thanks in advance
I have followed the quick start to configure my NAT access, I have done a lot of tries but without sucess.
I am attaching the drawing of my network.
What I want to do, is to access the PLC from the Server PC.
So, I have configured the General and Public to Private tabs as in the image.
I just have Gi1/1 1(native lan) where is connected the Server PC
Smartports, all to none, just Gi1/1 as Switch for automation
Port settings, all to autonegotiate and administrative mode to dynamic auto, just Gi1/1 as trunk.
With this configuration, I try to do a ping from Server PC to the PLC (192.168.190.1 Public addres for the PLC) but this not responds.
which could be the problem?
I am doing a lot of tries but not working.
Thanks in advance
Last edited: