Thermocouple signal spiltter - got such thing?

Dual TC Unit

We had this problem before.
The easy and the cheapest way is dual unit.
The important thing is to order the new unit isoleted (the TC is isoleted from the tube) other wise you will have lot of noise.
Then calibrate the new TC according to the B&R.
 

Similar Topics

C
PWM Signal from IR Thermocouple to trigger PLC Input
Hey All, Looking to set up a no-contact thermocouple to a piece of testing equipment that can basically just switch a NC input that shuts off the...
Replies
2
Views
3,757
BobB
BobB
A
Allen-Bradley 5069-IY4 Thermocouple Help
I am having an issue getting a IY4 to read my thermocouple correctly. We have a R type and K type hooked up and sitting at a known room...
Replies
5
Views
540
danw
danw
B
Delta ISPSoft - Establishing communication with thermocouple module
Posted by u/mr_biodtox 44 minutes ago Delta ISPSoft - Establishing communication with thermocouple module Hi, How do I establish communication...
Replies
1
Views
340
biodtox
B
K
Thermocouple not steady values
Hi, We have an ongoing project with a lot of thermocouple involved that monitor the temperature of heaters. There are more than 20 PID...
2 3
Replies
32
Views
3,487
MaxK
M
G
Problems with the SLC 500 Thermocouple Module
Hello. PLC beginner here, so apologies in advance for any incorrect terminology or poor communication. I have an SLC 500 Thermocouple/mV Analog...
Replies
1
Views
652
KuulKuum
KuulKuum
Back
Top Bottom