If you know of a problem with Siemens WinCC Flexible, or you have an idea for a general improvement, then post it here in this thread.
I shall collect the inputs from all posters, and assemble a list with all suggested improvements.
Posters (of new original points) will be accredited.
Anonymous input will be accepted.
You can also PM suggestions to me, and you may choose to stay anonymous if you want to.
Here is a link to the list of improvements.
I will update it on a weekly basis.
Deadline is March 1.
I shall post a poll to determine which improvements users finds the most relevant.
This will in the end result in a letter to Siemens with the all the suggested improvements, ranked after "relevance".
Members that are willing to be named in the letter are more than welcome. You dont have to post suggestions to be named, but you should aggree in the greater part with the list of required improvements. The more people named in the list, the more weight it will carry.
Notice:
In this thread you should post about WinCC Flexible only, not STEP7 or other Siemens softwares.
I shall collect the inputs from all posters, and assemble a list with all suggested improvements.
Posters (of new original points) will be accredited.
Anonymous input will be accepted.
You can also PM suggestions to me, and you may choose to stay anonymous if you want to.
Here is a link to the list of improvements.
I will update it on a weekly basis.
Deadline is March 1.
I shall post a poll to determine which improvements users finds the most relevant.
This will in the end result in a letter to Siemens with the all the suggested improvements, ranked after "relevance".
Members that are willing to be named in the letter are more than welcome. You dont have to post suggestions to be named, but you should aggree in the greater part with the list of required improvements. The more people named in the list, the more weight it will carry.
Notice:
In this thread you should post about WinCC Flexible only, not STEP7 or other Siemens softwares.