nightline
Member
Gents,
I'm asked to check if an SEW servo motor with Hiperface encoder can be used with an Kinetix 6000 sercos servo drive.
When I check the manual, an Hiperface seems to be supported by this type of drive.
When I look in the software (Studio 5000) in the configuratie of servo proporties, I can select 10 types of encoders but non of them is a Hiperface unless it's called different.
Can somebody shine some light on this?
The SEW motor is an: CMP40M/BP/KY/AK0H/SB.
The drive is an:2094-BM1 or 2 rev. 1.135
Jack
I'm asked to check if an SEW servo motor with Hiperface encoder can be used with an Kinetix 6000 sercos servo drive.
When I check the manual, an Hiperface seems to be supported by this type of drive.
When I look in the software (Studio 5000) in the configuratie of servo proporties, I can select 10 types of encoders but non of them is a Hiperface unless it's called different.
Can somebody shine some light on this?
The SEW motor is an: CMP40M/BP/KY/AK0H/SB.
The drive is an:2094-BM1 or 2 rev. 1.135
Jack