Hello PLCS.net!
I am working with a EX600 Sen3/4 module from SMC. This is the documentation I am following: https://content2.smcetech.com/pdf/manuals/EXxx-OMS0027im.pdf
I added it to my IP tree in an L73 PLC on an ENBT card using an EDS file and Studio5k(V28) found here: https://www.smcusa.com/products/EX600-SI-Unit~89908
To enable QuickConnect I was looking at Page69 of the manual. Step 1 asks me to turn autonegotiation off, I was able to do step 1. Step 2 asks me to do things I've never done before.
Any clue how to do those?
Best regards,
-PreLC
I am working with a EX600 Sen3/4 module from SMC. This is the documentation I am following: https://content2.smcetech.com/pdf/manuals/EXxx-OMS0027im.pdf
I added it to my IP tree in an L73 PLC on an ENBT card using an EDS file and Studio5k(V28) found here: https://www.smcusa.com/products/EX600-SI-Unit~89908
To enable QuickConnect I was looking at Page69 of the manual. Step 1 asks me to turn autonegotiation off, I was able to do step 1. Step 2 asks me to do things I've never done before.
Any clue how to do those?
Best regards,
-PreLC