Martin_Offer
Member
Here is my dilemna. I have a 1756 HSC with 1000ppr encoders on each channel. I am using them for positional control on a carriage driven by a chain and servo. On the start-up, I have a "calibration" switch which I use to load a preset value into the HSC card. The problem I have is that the only way I can get seem to get the HSC card to accept the value is by resettting the card itself.
Is there another way to load the value and accept it?
Or, is there a way to reset the card through the logic?
Thanks
Is there another way to load the value and accept it?
Or, is there a way to reset the card through the logic?
Thanks