Good Morning ,
I have a 1769-IF8 analog ( 4-20 ) input card. Using a calibrator, but the 4-20 signal is jumping around . It is not too critical. Is there any damping instructions I can use to calm the signal going out to the HMI ? In the 1769-IF8 properties I see filtering . This is set at 60 HZ . What does this mean , and do I want to lower this ?
Thanks so much .
I have a 1769-IF8 analog ( 4-20 ) input card. Using a calibrator, but the 4-20 signal is jumping around . It is not too critical. Is there any damping instructions I can use to calm the signal going out to the HMI ? In the 1769-IF8 properties I see filtering . This is set at 60 HZ . What does this mean , and do I want to lower this ?
Thanks so much .