ceilingwalker
Lifetime Supporting Member
Hello. I have little experience with Kinetix servo drives so the likelihood of a dumb question getting fired out here is pretty high. I currently have a K6500 that I would like to change one of the axis' from internal home position to an external prox switch. I have been searching for information about not only how to do this but to learn what the settings for the drive are for.
This doesn't appear to me that the Kinetix have parameters that are stored on the unit itself like a Power Flex but that it is fed its settings by Studio 5K, is that a true statement? If so, then I guess it is the Studio 5k manual that I need to brush up on?
Thanks much
This doesn't appear to me that the Kinetix have parameters that are stored on the unit itself like a Power Flex but that it is fed its settings by Studio 5K, is that a true statement? If so, then I guess it is the Studio 5k manual that I need to brush up on?
Thanks much