desertsurf520
Lifetime Supporting Member
OP
There is no selection with the 1769-IFxOF2 module.
I am using version 30
I am using version 30
I don't see those settings in my project with the low-res module. I only see them if I add the fast module which is not the module from your original post. Confirm which physical module you have. Have you measured the actual current with a meter?
Its the weirdest thing. This should be easy.
When I set up the SCL I set the minEU to 0 and the maxEU to 200 but it goes back to default at 12...? I don't get it.