hi there
if i have a slc 5/05 set up with 3 devicenet scanners and want to upload a backup file of the networks in rsnetwork. can you browse so all 3 scanners and their modules appear? or is it 3 seperate files that needs to be saved.
I use this manual
https://literature.rockwellautomation.com/idc/groups/literature/documents/um/1747-um655_-en-p.pdf
I use a ethernet cable and do a setup as they do from page 65. I made an upload of the scanner and choosed slot 12 since one of the scanners had that position in the rack. But only the scanner slot 12 was visible, the modules in the scanners scanlist did not appear on the node. (figure I need to make 3 files, since they are not a part of the same chain).
I have limited experience with devicenet, since its so old that we only heard little about it in school.
if i have a slc 5/05 set up with 3 devicenet scanners and want to upload a backup file of the networks in rsnetwork. can you browse so all 3 scanners and their modules appear? or is it 3 seperate files that needs to be saved.
I use this manual
https://literature.rockwellautomation.com/idc/groups/literature/documents/um/1747-um655_-en-p.pdf
I use a ethernet cable and do a setup as they do from page 65. I made an upload of the scanner and choosed slot 12 since one of the scanners had that position in the rack. But only the scanner slot 12 was visible, the modules in the scanners scanlist did not appear on the node. (figure I need to make 3 files, since they are not a part of the same chain).
I have limited experience with devicenet, since its so old that we only heard little about it in school.