First time poster so I apologize in advance if this topic has been discussed before. I did several searches but came up empty.
I am trying to create a user-defined major fault in RSlogix 5000 but after reading the programming manual, I am still left with questions. The manual says to:
1. Create a fault routine for the program
2. Configure the program to use the fault routine
3. Jump to the fault routine when the fault occurs.
My question is: What should the logic in the fault-routine do? Am I missing something?
Thanks in advance for any advise.
I am trying to create a user-defined major fault in RSlogix 5000 but after reading the programming manual, I am still left with questions. The manual says to:
1. Create a fault routine for the program
2. Configure the program to use the fault routine
3. Jump to the fault routine when the fault occurs.
My question is: What should the logic in the fault-routine do? Am I missing something?
Thanks in advance for any advise.